Topband
[Top] [All Lists]

Topband: Battle Creek Trapper Question

To: <topband@contesting.com>
Subject: Topband: Battle Creek Trapper Question
From: jsm@intergate.bc.ca (Steve McDonald)
Date: Wed, 9 Aug 2000 16:56:14 -0700 (PDT)
Well the BC Trapper is all set to go up this weekend. My plan is to tune the
antenna using 2 resonant elevated 1/4 wave radials for each band and then
later, lay down as much of a ground screen (unconnected) beneath the antenna
using 1/2" U nails and a fine  magnet wire in the lawn (and the neighbours
lawn...sshhh). Rather than string 3 individual 1/4 wave radials for each of
the two legs, is it practical to use the twinlead style rotator control
ribbon that has about 5 separate insulated wires and cut the 3 sections from
the ribbon so that all 3 radials are on one line OR must they be separted by
some degree? I'm also hoping to achieve a little high angle component by
using the 1/4 wave radials for single hop stuff. The base is 8' off the
ground and about 25' from the ocean, looking eastwards.
VE7SL/Steve



--
FAQ on WWW:               http://www.contesting.com/FAQ/topband
Submissions:              topband@contesting.com
Administrative requests:  topband-REQUEST@contesting.com
Problems:                 owner-topband@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • Topband: Battle Creek Trapper Question, Steve McDonald <=