P.S. here is the link to the QRZ thread - lots of good stuff in this thread.
https://forums.qrz.com/index.php?threads/ten-tec-century-21-restoration.522748/page-10#post-5167967
-Josh
On Sun, Oct 6, 2019 at 8:09 PM Johnathon Allread <john.allread@gmail.com>
wrote:
> Thank you Josh!
>
> Would you happen to have a schematic of the mod? I did not see it in the
> shared drive. Thanks!
>
>
> Johnathon B. Allread
> john.allread@gmail.com
> 469-336-7763
>
> "The Road to Success is Always Under Construction" - Lily Tomlin
>
>
> On Sun, Oct 6, 2019 at 9:52 PM Josh Gibbs <gibbsjj@gmail.com> wrote:
>
> > Hi John,
> >
> > I have a C21 digital. You might find something useful here:
> >
> > https://drive.google.com/open?id=0B_pjAwEfeYcdYmRaTUhRTnN6SFU
> >
> > You can run it safely on external 12V! I've run mine that way quite a
> bit.
> > Good luck - let me know how it goes.
> >
> > -Josh WU7H
> >
> >
> > On Sun, Oct 6, 2019 at 7:40 PM Johnathon Allread <john.allread@gmail.com
> >
> > wrote:
> >
> > > Hi Bob,
> > >
> > > The Century 21 has a built in supply circuit. I am not sure if I could
> > > connect 12VDC to the unit without a bit of modification. It has a over
> > > current circuit protection.
> > >
> > > John - NE5J
> > >
> > >
> > >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|