Many thanks to Carlos VK1EA and Mike WB8VGE for solutions.
I now see the light at the end of the tunnel... :-)
Tnx.
Perry w8au
On 3/29/2019 2:52 AM, Carlos wrote:
Hi Perry,
I cut the main body (the four flat arms) with a dremel tool, leaving a thin
ring only. Then I (very) carefully "peeled off" that ring. If you do it
hastily you'll distort the aluminium part where the speaker is glued to.
73,
Carlos VK1EA
On Friday, March 29, 2019, Perry Ballinger <w8au@sssnet.com> wrote:
I have a question about how to remove the existing speaker that failed
(open speaker coil)
The speaker periphery is cemented in somehow and seems impossible to
remove.
Any helpful ideas?
Thanks / 73,
Perry w8au
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|