Hi Perry,
I cut the main body (the four flat arms) with a dremel tool, leaving a thin
ring only. Then I (very) carefully "peeled off" that ring. If you do it
hastily you'll distort the aluminium part where the speaker is glued to.
73,
Carlos VK1EA
On Friday, March 29, 2019, Perry Ballinger <w8au@sssnet.com> wrote:
> I have a question about how to remove the existing speaker that failed
(open speaker coil)
> The speaker periphery is cemented in somehow and seems impossible to
remove.
>
> Any helpful ideas?
>
> Thanks / 73,
> Perry w8au
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|