TenTec
[Top] [All Lists]

[TenTec] Poor sensitivity - Ten-Tec 574

To: TenTec@contesting.com
Subject: [TenTec] Poor sensitivity - Ten-Tec 574
From: Gary Tennyson <garyandjanice2@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 14 Mar 2019 15:56:15 -0500
List-post: <mailto:tentec@contesting.com>
The 574 (Digital Century 21) has been sitting idle for several years. When
I got it out the 2N3055 regulator had failed, putting about 17 Vdc on the
(normally 13 V) regulated output. I replaced the 2N3055 (they’ve gotten
expensive!).  Now the power supply is OK.  Everything is on frequency.
Transmitter seems to work OK, but the receiver seems deaf.

I measured the Minimum Discernible Signal.  It’s about -90 dBm (bad).
There are also continuing ‘static crashes’ even with the antenna
disconnected.  Before I start troubleshooting the receive chain, I was
wondering if anyone on the list recognizes these symptoms.

Thanks

Gary - KO4CY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>