OK Lyman, I knew that would fix the digit problem..
Do you have a small bench power supply? If so. try disconnecting the power to
the counter module and power it from the external power supply. That will point
you in the direction of coupling of the tone.
Gary
> On Jan 9, 2019, at 7:10 PM, <forum4ll@verizon.net> <forum4ll@verizon.net>
> wrote:
>
>
> Please ignore my post above. I was able fix this problem by putting back the
> 560pf cap thats on pin 16 of MK50398N, display decoder chip.
>
> Lyman KK6LPW
>
> Sent from AOL Mobile Mail
> Get the new AOL app: mail.mobile.aol.com
> On Monday, January 7, 2019 forum4ll <forum4ll@verizon.net> wrote:
> Hello,
> I ran into a problem with this Omni-D after solving the whining problem on
> the frequency counter. The frequency display is incorrect for 10, 14, 21, 28,
> and 29 mhz. Any 10mhz frequency will read 18mhz higher or 28 mhz. For 14, 21,
> 28, and 29 mhz, they will read 8mhz lower or 06, 13, 20, and 21mhz. Earlier,
> I made a mistake plugging in the Preset-Amp (80465) to the Display board
> (80440) where I was off by one pin. After correcting this, I noticed 10mhz
> frequencies were reading 18mhz higher. So I tore into this area again and
> tested the components on the Preset-Amp, based on my reading of the manual is
> where the first two digits are assigned, and the transistors, diodes and
> resistors tested fine although I did not test the ceramic caps. Putting it
> all back together, I now have this situation where 10mhz still reads 28 and
> bands above that are reading 8mhz lower. Still I know something is damaged
> just by the behavior when powering up. When power is turned on and the
> frequency band is
switched to 14, 21, 28, or 29mhz, the display will appear correct for 5 to 30
seconds, then it reverts back to its minus 8 mhz reading. Anyone have any clue
what could be wrong? I'm thinking of spraying some freon or a coolant on some
of the components in the Display counter to see if I can find the bad part. Any
suggestions is welcomed.
>
> Note, the lower bands i.e. 1.5, 3, and 7mhz are fine. The Preset-Amp does not
> affect the display of these frequencies.
>
> LymanKK6LPW
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|