Good luck, Snowy....I soldered on one for a while for a dear elderly friend,
with no luck. A scientific approach would have probably proved more useful, but
he told me to keep it for parts.
73- Greg KC8HXO
Sent from my Linux device
> On Sep 20, 2018, at 13:18, ROLAND HOWELL via TenTec <tentec@contesting.com>
> wrote:
>
> Hi MarkUnfortunately that is not an option open to me as it was purchased as
> spares or repair, however I have now got it working, not 100% more like 80%,
> now have audio and a message saying that PLL is out of lock, on all
> frequencies not just 1 band, I have had all 3 boards out and resoldered
> everything, found no end of dry joints and some that had never seen a splash
> of solder, but still got the same message.thanks for your inputSnowy G0HZE
>
> On Thursday, 20 September 2018, 17:07, mark kenward via TenTec
> <tentec@contesting.com> wrote:
>
>
> The Paragon is a lot different from PII.
> I would go for my money back unless it was a give away.
> Old Paragons were known for bad solder joints all over.
> PII is more line Omni 6. With general coverage and ssbAM included, plus FM.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> | | Virus-free. www.avast.com |
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|