| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Corsair II tuning |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 27 Aug 2018 11:06:04 +0100 |
| List-post: | <mailto:tentec@contesting.com> |
I don't see any error in the schematic. The output from the FET
oscillator stage is taken from the crystal bank common line via L3 into
balanced mixer U1, Pin 11.
Steve G3TXQ On 26/08/2018 23:47, MadScientist wrote: One other error in the schematic is that the local oscillator is shown connected directly to the FET power supply line (regulated as well) and bypassed to ground via a 0.01 uF capacitor. This can’t work… Gary W0DVN _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Corsair II tuning, Steve Hunt |
|---|---|
| Next by Date: | [TenTec] FS original Omni D manual, Michael Tortorella |
| Previous by Thread: | Re: [TenTec] Corsair II tuning, Carlos |
| Next by Thread: | [TenTec] FS Corsair II station, Michael Tortorella |
| Indexes: | [Date] [Thread] [Top] [All Lists] |