TenTec
[Top] [All Lists]

Re: [TenTec] OmniVI rotary encoder

To: tentec@contesting.com
Subject: Re: [TenTec] OmniVI rotary encoder
From: Bob McGraw K4TAX <rmcgraw@blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 8 Aug 2018 08:28:07 -0500
List-post: <mailto:tentec@contesting.com>
Once you have the top and bottom covers off, remove the top screw on each side of the front panel.  The front panel will tilt forward for access to the encoder.

73

Bob, K4TAX



On 8/8/2018 4:14 AM, Steve Hunt wrote:
Folks,

I need to replace the rotary encoder in my OmniVI. Can anyone tell me the easiest way to get at it and do the replacement. It's easy to spot the encoder when you take the bottom cover off, but I wonder it you then need to fully remove the front panel, and if so how big a job it is?

Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>