| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] OmniVI rotary encoder |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 8 Aug 2018 10:14:47 +0100 |
| List-post: | <mailto:tentec@contesting.com> |
Folks,I need to replace the rotary encoder in my OmniVI. Can anyone tell me the easiest way to get at it and do the replacement. It's easy to spot the encoder when you take the bottom cover off, but I wonder it you then need to fully remove the front panel, and if so how big a job it is? Steve G3TXQ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] WTB, Stan Gammons |
|---|---|
| Next by Date: | Re: [TenTec] WTB, Michael Goins |
| Previous by Thread: | Re: [TenTec] WTB, Stan Gammons |
| Next by Thread: | Re: [TenTec] OmniVI rotary encoder, Bob McGraw K4TAX |
| Indexes: | [Date] [Thread] [Top] [All Lists] |