I did my encoder replacement several years ago but I seem to remember that
although the encoder clicks/detents were double steps, that it was actually
possible to single step the encoder by slowly/carefully turning them
between the clicks/detents.
Barry N1EU
On Tue, Apr 24, 2018 at 1:26 PM, MadScientist1948 <dukeshifi@comcast.net>
wrote:
> Hi Barry:
>
> I did install the new Bournes encoders. They work very nicely, as I had
> reported.
>
> However, the Multi encoder double steps (5, 7, 9 etc. instead of
> 5,6,7,8,9).
>
> I have located the encoder on the schematic and wondered how you felt
> about the possibility of adding a divide by 2 between the encoder and the
> CPU.
>
> Gary
>
>
>
> > On Apr 23, 2018, at 3:09 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> >
> > The lines come into the logic board on the bottom right side of the
> > schematic (p 4-20) - connectors 91 and 92
> >
> > Barry N1EU
> >
> > On Mon, Apr 23, 2018 at 8:02 PM, Barry N1EU <barry.n1eu@gmail.com>
> wrote:
> >
> >> The buttons/switches are shown in figure 4-34 on page 4-33
> >>
> >> Barry N1EU
> >>
> >> On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks <k4mt1950@charter.net>
> >> wrote:
> >>
> >>> I can not find a schematic that shows the MS MT LP AND NR buttons and
> >>> where they go to on I assume the logic board. Anyone know where that
> >>> schematic might be found
> >>> Gary K4MT
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >>
> >>
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|