Hi Barry:
I did install the new Bournes encoders. They work very nicely, as I had
reported.
However, the Multi encoder double steps (5, 7, 9 etc. instead of 5,6,7,8,9).
I have located the encoder on the schematic and wondered how you felt about the
possibility of adding a divide by 2 between the encoder and the CPU.
Gary
> On Apr 23, 2018, at 3:09 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> The lines come into the logic board on the bottom right side of the
> schematic (p 4-20) - connectors 91 and 92
>
> Barry N1EU
>
> On Mon, Apr 23, 2018 at 8:02 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
>> The buttons/switches are shown in figure 4-34 on page 4-33
>>
>> Barry N1EU
>>
>> On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks <k4mt1950@charter.net>
>> wrote:
>>
>>> I can not find a schematic that shows the MS MT LP AND NR buttons and
>>> where they go to on I assume the logic board. Anyone know where that
>>> schematic might be found
>>> Gary K4MT
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|