Thanks Rod. I'll check it out.
Later, Joe, K8MP
Sent from AOL Mobile Mail
-----Original Message-----
From: Rod Greene via TenTec <tentec@contesting.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Cc: Rod Greene <w7zrc@yahoo.com>
Sent: Fri, Mar 2, 2018 05:34 PM
Subject: Re: [TenTec] Winlink and Winmoor on an Omni 6 Plus
Joe, seems like I used Icom 735 (some older version like that) with my Paragon
that has an N4PY chip. The Omni 6 may be the same
GL es 73, Rod/w7zrc
From: Joe Papworth via TenTec <<a
href="mailto:tentec@contesting.com";>tentec@contesting.com</a>>
To: <a href="mailto:tentec@contesting.com";>tentec@contesting.com</a>
Cc: <a href="mailto:k8mp@aol.com";>k8mp@aol.com</a>
Sent: Friday, March 2, 2018 2:08 PM
Subject: [TenTec] Winlink and Winmoor on an Omni 6 Plus
Gents,
Winmoor does not support the Omni 6 Plus in their Rig Control software.
I'm thinking that someone once told me there was a different brand and model
that used a command set equal to or very similar to the Omni 6.
Does that ring any bells?
Or, has anyone found another work-around for this problem?
Thanks, Joe, K8MP
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|