Re: [TenTec] Orion II: Flaky Multi encoder

["Bob, W3IDT" <w3idt@comcast.net>]

All the replies listing connector issues...

Lifted the OrionII about 1/2 of the table then dropped it.
All problems went away!

Now if I can only get either my MicroKeyer or my RigBlaster to work I'll 
be all set. Big learning curve: Multiple user errors no doubt...
(BTW: Both companies, MicroHam and West Mountain, have been SUPER in 
responding the emails.)
Bob, w3idt
--

.............................
. Robert F. Teitel, W3IDT   .
.                           .
. W3IDT@arrl.net            .
. W3IDT@comcast.net         .
.............................

On 3/2/2017 9:53 PM, Dukes HiFi wrote:
> They are not as hard to replace as they look.
>
> I have one more left at $25 shipped.
>
> Gary
>
>
> > On Mar 2, 2017, at 4:52 PM, P C Andy Anderson <xtraham58@hotmail.com> wrote:
> >
> >
> >
> >
> > ________________________________
> > From: TenTec <tentec-bounces@contesting.com> on behalf of Bob, W3IDT 
> > <w3idt@comcast.net>
> > Sent: Thursday, March 2, 2017 4:19 PM
> > To: Discussion of Ten-Tec Equipment
> > Subject: [TenTec] Orion II: Flaky Multi encoder
> >
> > My MULTI encoder is "flaky": Sometimes moving only a few digits (say for
> > MIC Gain only 38 - 41); other times working fine.
> >
> > I found a note from 2012 suggesting twisting it 20 -30 times,
> > and blowing dust from inside the radio.
> >
> > Any other suggestions (since 2012)?
> >
> > Thanks
> >
> > Bob, w3idt
> > --
> >
> > .............................
> > . Robert F. Teitel, W3IDT   .
> > .                           .
> > . W3IDT@arrl.net            .
> > . W3IDT@comcast.net         .
> > .............................
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> > TenTec Info Page - 
> > Contesting<http://lists.contesting.com/mailman/listinfo/tentec>
> > lists.contesting.com
> > Welcome to the Ten-Tec mailing list! This list is intended for the exchange of 
> > information on Ten-Tec-related topics ONLY. Off Topic subject postings should 
> > be ...
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

                                        
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec