Hello all..
I recently acquired an Omni VI... After warming up, some bands are dead on
(17M, 15M), some are off a little bit (40M, 80M) about 500 Hz and 20M is
off by nearly 1.5 kHz.
I've worked on some of my older Icom rigs (751, 745, 765) and was able to
re-calibrate them and re-align... but that was following the service
manuals...
Any suggestions on the best way to fix this... From what I've read and
looking at the manual, I'm guessing that my problem is with the band
crystals on the XTAL OSC/ LO board...
Any help would be much appreciated.
Thanks!
John
K2JNC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|