Yes.
There are no long shafts on this radio so the hinging process is actually very
easy.
Gary
> On Aug 24, 2016, at 9:49 PM, k7mks@comcast.net wrote:
>
> Gary: By "hinge" do you mean remove the 4 screws , one in ea corner of the
> panel
>
> , and hinge the panel, knobs etc knobs etc downward until I can unfasten the
> meter etc, Joe k7mks
> ----- Original Message -----
>
> From: "Gary J FollettDukes HiFi" <dukeshifi@comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, August 24, 2016 7:08:10 PM
> Subject: Re: [TenTec] Paragon 1 and 2 Meter Replacement
>
> You do need to hinge the panel down but this is pretty easy to do with an
> Omni 6 or paragon.
>
> Gary
>
>
>> On Aug 24, 2016, at 5:21 PM, k7mks@comcast.net wrote:
>>
>> Does the front panel need to be removed, or is there an easier, way to
>> replace the meter? What are the steps to access the meter.
>>
>> Joe k7mks
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|