SRI - I missed this while looking thru parts receipts...
73 ES DX,
Gary - AB9M
On 8/14/2016 6:41 PM, Allan Taylor wrote:
> Ignore my previous request for information. I had never paired the Corsair
> II
> with the 961... and forgot that the OmniVI formerly used has a jumper
> in place between the two wires carrying a.c....
>
> Allan K7GT
>
> On Sun, Aug 14, 2016 at 3:47 PM, Al Gulseth <wb5jnc@centurytel.net> wrote:
>
>> Correction to my last post: the front panel switch is a push in/pull out,
>> not
>> push on push off. SRI about that, brain rebooting HI HI!!
>>
>> 73, Al
>>
>> --- previous message ---
>>
>> Allan,
>>
>> Just to make sure - remember that the switch is in series with the front
>> panel
>> switch on the rig. The push on - push off type switches used in the older
>> rigs (Tritons, early Omnis, Delta, Argosys, and Corsairs) were prone to
>> failure. You might check that and also the cable connections first.
>>
>> 73, Al
>>
>> On Sun August 14 2016 5:24:14 pm Allan Taylor wrote:
>>> Guys,
>>>
>>> My Tentec gear has sat for a year or two during a shack renovation. While
>>> trying to bring the Corsair II up recently, I
>>> found that the 961 power supply did nothing (nada) when toggling the
>> power
>>> switch.Thinking that it is the most likely
>>> candidate for the problem, I wonder if any of the gang knows the mfgr and
>>> part number for a replacement switch.
>>> (I have not contacted TT but suspect the switch is not a one off design
>>> for TT only!).
>>>
>>> Anyone?
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|