Correction to my last post: the front panel switch is a push in/pull out, not
push on push off. SRI about that, brain rebooting HI HI!!
73, Al
--- previous message ---
Allan,
Just to make sure - remember that the switch is in series with the front panel
switch on the rig. The push on - push off type switches used in the older
rigs (Tritons, early Omnis, Delta, Argosys, and Corsairs) were prone to
failure. You might check that and also the cable connections first.
73, Al
On Sun August 14 2016 5:24:14 pm Allan Taylor wrote:
> Guys,
>
> My Tentec gear has sat for a year or two during a shack renovation. While
> trying to bring the Corsair II up recently, I
> found that the 961 power supply did nothing (nada) when toggling the power
> switch.Thinking that it is the most likely
> candidate for the problem, I wonder if any of the gang knows the mfgr and
> part number for a replacement switch.
> (I have not contacted TT but suspect the switch is not a one off design
> for TT only!).
>
> Anyone?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|