The XX command as previously mentioned does not reset the Orion. It is
only done to establish communication over the serial port.
When I initialize the radio, all I do is send out the settings for all
the saved values for the various settings on the radio. It's hard to
say what is going on but maybe it is as simple as the RF gain or AGC
threshold needs to be sent again.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 7/31/2016 11:23 PM, Gary J FollettDukes HiFi wrote:
I have an Orion that is quirky in that it mostly works but all of the
pushbuttons and encoders (except VFO) fail to operate at boot up.
If I open your software, the radio initializes and then works from then on,
whether the software is running or not (until I turn the radio off).
I wa wondering if you could share what is taking place during “Initializing
radio”?
This might help me troubleshoot the radio.
73
Gary
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|