Showing my age here hi... hi. What's reballing? Thanks.
73, Tony VE3DWI.
Sent from my BlackBerry 10 smartphone on the Bell network.
Original Message
From: John Henry
Sent: Thursday, March 31, 2016 13:03
To: tentec@contesting.com
Reply To: Discussion of Ten-Tec Equipment
Subject: [TenTec] reballing a Dragon
The problem wasn't always in reballing.
There were problems in that the part sat on a shelf for 15 years, not in a
clean room, and somewhere along the line got hit with ESD, or too hot one
day, random circuits inside the chip failed, etc.
I do however doubt that if 20 people tried to scavenge some dragonballs and
had to replace it, well, maybe 4 in 20 would be happy at the end of the
day, the other 16 would probably be buying a new rig. just my two cents.
So many pitfalls along the way, the chips are at least 15 years old,
storage, excessive heat, etc.
Yield of TEN-TEC trying to do this using a couple of excellent BGA board
houses to replace them was very low.
73, KI4JPL
John Henry
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|