Is there a phone number that I can contact Ten Tec on... or are they not taking
calls?
I ordered the caps for the A9 board and they did not send one. Maybe this cap
does not need replacing. 100uf 6.3v loc c8-3.
I assume all of the caps should be replaced… true.
Any help would be appreciated… or should I order one from Digi-Key or elsewhere.
73’s
Rich, WD6DOK
> On Jan 18, 2016, at 4:44 PM, Carl Winkles <jcwinks@att.net> wrote:
>
> You might check the power connector on the rear of the Herc II. I have had
> bizarre things happen when fewer than all of those pins are making contact.
>
> Carl, K4SEV
>
> Enviado desde mi iPhone
>
>> El ene 18, 2016, a las 5:29 PM, Zivney, Terry <00tlzivney@bsu.edu> escribió:
>>
>>
>> My Hercules II was working but now..
>>
>>
>>
>>
>> On power up (with matching TenTec power supply) the front
>>
>> panel fault light comes on as does the fan. Waiting a few
>>
>> seconds, the red led fault light dims out and the fan stops,
>>
>> but the meter lights still have full brightness. The amp
>>
>> does not switch over to XMT (a good thing, without the blower!)
>>
>>
>>
>>
>> Any ideas what to check first?
>>
>>
>>
>>
>> Terry N4TZ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|