You might check the power connector on the rear of the Herc II. I have had
bizarre things happen when fewer than all of those pins are making contact.
Carl, K4SEV
Enviado desde mi iPhone
> El ene 18, 2016, a las 5:29 PM, Zivney, Terry <00tlzivney@bsu.edu> escribió:
>
>
> My Hercules II was working but now..
>
>
>
>
> On power up (with matching TenTec power supply) the front
>
> panel fault light comes on as does the fan. Waiting a few
>
> seconds, the red led fault light dims out and the fan stops,
>
> but the meter lights still have full brightness. The amp
>
> does not switch over to XMT (a good thing, without the blower!)
>
>
>
>
> Any ideas what to check first?
>
>
>
>
> Terry N4TZ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|