Re: [TenTec] frequency calibration on OMNI-V

[Carl Moreschi <n4py3@earthlink.net>]

This can only be done by adjusting the crystal trimmers on a band by 
band basis.  This is one huge advantage of the N4PY chip.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 1/7/2016 8:45 AM, wt4t@reagan.com wrote:
> If your using a stock OMNI-V ,No N4PY chip, how do you calibrate the display, 
> if not reading correctly?
>
> On 14.300 I read 14. 299.87. Read thru the manual but must have missed it . 
> Would really appreciate any guideance on this.
> 73
> dale wt4t
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec