PLL alignment isn't in the manual but this is allegedly the info:
http://www.tentecwiki.org/doku.php?id=562pllalign
Barry N1EU
On Thu, Jan 7, 2016 at 8:45 AM, <wt4t@reagan.com> wrote:
>
> If your using a stock OMNI-V ,No N4PY chip, how do you calibrate the
> display, if not reading correctly?
>
> On 14.300 I read 14. 299.87. Read thru the manual but must have missed it
> . Would really appreciate any guideance on this.
> 73
> dale wt4t
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|