Thanks, Carl and Barry- just dipping my toes into the SDR/Panadapter stuff at
this point. And I am working with an Eagle. I already purchased a used LP-Pan2,
so once I have it up and running, will report results back to the group. (Going
to try it with the factory supplied I.F. Output on the Eagle first, and take it
from there). Again, thanks to the list!!!
Greg, KC8HXO
--------------------------------------------
On Thu, 12/10/15, Carl Moreschi <n4py3@earthlink.net> wrote:
Subject: Re: [TenTec] LP-Pan 2 on Orion 2
To: tentec@contesting.com
Date: Thursday, December 10, 2015, 9:40 AM
In m opinion, it is much
better to just use a separate SDR receiver such
as SDRplay and have that run in parallel with
the Orion. I have worked
out excellent
ways to share antenna connections between the Orion and
SDR receivers.
This method has none of the IF problems and
even allows for the SDR
receiver panadapter
display to always follow the transmit frequency
instead of the receive frequency.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC
27549
www.n4py.com
On 12/10/2015 9:08 AM, Barry N1EU wrote:
> no
>
> On Thu, Dec 10, 2015 at 9:07 AM, Greg S
via TenTec<tentec@contesting.com>
> wrote:
>
>> Barry.... Will the Lp-pan2 with amp
built in take care of the discrepancy
>> you note? Thanks! Greg, KC8HXO
>>
>> Sent from
Yahoo Mail on Android
>>
>> On Thu, Dec 10, 2015 at 7:24,
Barry N1EU<barry.n1eu@gmail.com>
wrote:
>> I found the
RX366 IF output resulted in a poor panadapter trace and
posted
>> that to this reflector and
tentecwiki.org - use the VE7TK mod with Clifton
>> Labs buffer amp. I suspect the Eagle
IF output is no better than the RX366
>> and also really needs the mod, since
it's essentially the same receiver.
>>
>> I just
plugged it into my motherboard soundcard, a RealTek HD or
something
>> like that. It works
fine, as do the soundcards recommended on
>> telepostinc.com
>>
>> Barry N1EU
>>
>> On Wed, Dec
9, 2015 at 11:10 PM, Kim Elmore<cw_de_n5op@sbcglobal.net>
>> wrote:
>>
>>> Somewhere in the archives,
I've read that the way the RX-366 IF output is
>>> set up creates some undesirable
dips and peaks in it.
>>>
>>> Kim N5OP
-----------------------------SNIPPED--------------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|