Corsair owners, check your manual.
Can someone confirm that the wire that must be unsoldered and an ammeter
inserted to check the driver bias current is the red wire with the ferrite bead
_outside the box_ that goes from the small meter shunt board to the solder lug
on the PA box?...and not the thin red wire on connector 57? Or a wire inside
the box?
The manual is not very clear, and I want to make sure I did this right. The
ferrite bead wire is a long way away from the drivers.
Bill
> >
> > On transmit with drive turned down, rig goes from drawing
> > 1A to about
> > 1.4A... bias on finals seems ok. Putting an ammeter in
> > line with the
> > drivers, no current (supposed to be 4 to 8 mA)... bias
> > adjust has no
> > effect. Looks like I lost the MRF476's, or the passives
> > around them.
> >
> > Bill W1PA
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|