Must be Corsair week. :-)
I have a new-to-me Corsair I -- my winter refurb project. Good receive
(mostly), good condition, two primary issues:
1.
No RX 160 and 80: freq counter bounces around on 0.180 to 0.190 Mhz on
these bands. I assume I should be looking at the wafer switches and
oscillators? All other bands are fine on RX.
2. No power out on
TX -- zero. Scope says I have good output from the low-level driver. Do
the finals fail open? Do they both go together? Any easy way to check
if it's the drivers or the actual finals in the PA module? I also read
that there was a common T/R diode fail that impacted ALC? What were the
symptoms of this fail?
Bill W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|