If all else fails, I have two spare encoders.
Gary
> On Oct 25, 2015, at 2:02 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> This can be a simple mechanical issue. First I'd try pulling off the
> chrome collar, loosening the set screw on the knob and repositioning the
> knob slightly further out from the front panel. This allows more motion of
> the shaft switch. Retighten and see if that makes a difference.
>
> If not, it can also be the white nylon nut threaded on the encoder shaft
> being too tight. This requires some disassembly of the front panel to
> correct. But has anybody worked behind the front panel of his Orion?
>
> Barry N1EU
>
> On Sun, Oct 25, 2015 at 6:19 PM, Arthur Lewis <wa8vsj@gmail.com> wrote:
>
>> *I have a friend with an Orion (565) that the push buttons on the Cut &
>> PBT/BW do not work. The CUT is in the low position and the PBT/BW is in the
>> BW position. When I push either buttons the positions do not change. The
>> BW and the LOW CUT knob work fine. Just can't change to the PBT or the HIGH
>> CUT. The rest of the Orion works fine. *
>>
>> *Art WA8VSJ*
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|