This can be a simple mechanical issue. First I'd try pulling off the
chrome collar, loosening the set screw on the knob and repositioning the
knob slightly further out from the front panel. This allows more motion of
the shaft switch. Retighten and see if that makes a difference.
If not, it can also be the white nylon nut threaded on the encoder shaft
being too tight. This requires some disassembly of the front panel to
correct. But has anybody worked behind the front panel of his Orion?
Barry N1EU
On Sun, Oct 25, 2015 at 6:19 PM, Arthur Lewis <wa8vsj@gmail.com> wrote:
> *I have a friend with an Orion (565) that the push buttons on the Cut &
> PBT/BW do not work. The CUT is in the low position and the PBT/BW is in the
> BW position. When I push either buttons the positions do not change. The
> BW and the LOW CUT knob work fine. Just can't change to the PBT or the HIGH
> CUT. The rest of the Orion works fine. *
>
> *Art WA8VSJ*
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|