TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec Orion 11 transciever

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec Orion 11 transciever
From: "Ron Castro" <ronc@sonic.net>
Reply-to: ronc@sonic.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 11 Oct 2015 19:41:55 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes, I believe it does, but only if you have the monitor turned on.

          Ron Castro
           N6IE
    www.N6IE.com

Member:
                  ARRL
     Redwood Empire DX Assn.
 Northern California Contest Club
Northern California DX Foundation
  Society of Broadcast Engineers

-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Bill Johnson 
via TenTec
Sent: October 11, 2015 7:23 PM
To: tentec@contesting.com
Cc: Bill Johnson
Subject: Re: [TenTec] Ten Tec Orion 11 transciever


What is the best way to comply with the new CQ WW requirement to create an MP3 
sound file of the contest from my Orion 11 transceiver?  I see the audio out 
jacket on the back of the Orion 11 however it does not provide the transmit 
audio for the MP 3 file?
 
Bill KV0Q
 
 
-----Original Message-----
From: Ken, W8EK <kenw8ek@gmail.com>
To: TenTec List at contesting <tentec@contesting.com>
Sent: Sun, Oct 11, 2015 5:22 pm
Subject: [TenTec] Misc TenTec items FS



TenTec Wall Wart, 25 amp power supplies, Cables, and other miscellaneous 
accessories For Sale:


TenTec Model 48-15-800 D "Wall Wart":

This wall wart is
the "regular" linear type, and not the
switching type that creates electrical
noise.  It is rated
at 15 V DC at 800 ma, and is used on a variety of TenTec items.

It works fine and looks like new.  $15


25 Amp Power Supplies,
ideal for most any HF rig:

All are rated at 25 amps, work fine and look great, and include paper work.

Pyramid Phase III, PS-25
This power supply will furnish
up to 25 amps. The voltage
is adjustable from the front panel from 4.5 to 15 V DC.
It includes both an ammeter and a voltmeter on the front panel.
It would be
ideal for the bench as well as for powering a rig.
This unit may be new. It is
still in its original box, with the
packing material and paper work. $100

Radio
Shack 22-510 is a 13.8 V DC switching power supply rated at 25 amps continuous 
duty. Note the 100% duty cycle rating! It should easily power most any modern 
HF transceiver.
It is small and relatively light weight.
This unit works 100%, and
looks extremely nice -- close to new.
It includes paper work -- operating
manual, parts list, schematic,
and circuit board layout. $65

MFJ 4225 MV, 22
amp Continuous Power Supply:
This is a rugged, but light weight power supply that will power most anything 
in your shack, whether an HF rig, or VHF and UHF rigs. Electrically, it is 
extremely quiet. I could find no noise.
Specifications:
25 Amps Surge, 22 Amps Continuous at 13.8 Vdc Front Panel Adjustable Voltage 
(9-15 Vdc) Lightweight, only 4.2 lbs.
Compact, only 5
¾" W x 4 ½" H x 6" D
Two output connections:
Five-Way binding post for HF/VHF
radio
Cigarette Lighter Socket for mobile accessories Over Voltage Protection Over 
Current Protection Automatic Reset after shutdown LIGHTED Dual
Meters:
Volt-meter and Amp-meter monitor load continuously Quiet internal Cooling Fan 
with "Fan On" LED This one works fine and looks like new.
Complete
with paper work for $70.


Cable for Hercules 444 Amplifier

This cable is used
to connect the Hercules (Original 444) to its power supply.  Heavy duty cable, 
with heavy Molex type connectors on each end.  Nice condition.  $25


VOX board
for TenTec 262 Power supply
Ready to plug in to replace your defective board.
$10


TenTec 715-I cable
This cable is made to plug into the TenTec 715 RF Speech Processor on one end, 
and an Icom transceiver at the other end.  This is the round 8 pin mic 
connector used on Icom rigs such as the IC-735,
756
series, and many others.  It is NOT for the type that takes the modular plug.
This one works fine and looks like new.  $18


TenTec 720 adapter
Adapts
an Icom microphone with the round 8 pin connector to a rig requiring the TenTec 
/ Yaesu round 8 pin connector.  Like new. $15


Cables for CW keyers and
keys:

Cable for paddles
About 3 feet long, and with a 1/8 inch (3.5 mm) stereo connector on the end, 
like used by most rigs. $8 As above, but 1/4 inch plug. $8

Cable for straight key
About 3 feet long, with a mono 1/8 inch (3.5
mm) phone
plug on it, as used with a straight key. $5 As above, but 1/4 inch plug. $5


I also have many other accessories available such as many different types of 
microphones, HTs, VHF and UHF rigs, antennas, etc. Just too many things to list 
here.
Please e-mail your requests.


Prices do not include shipping from
Florida.


Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK@FLHam.net or
W8EK@arrl.net
Voice Phone  (352)
732-8400




_______________________________________________
TenTec mailing
list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>