TenTec Wall Wart, 25 amp power supplies, Cables, and other
miscellaneous accessories For Sale:
TenTec Model 48-15-800 D "Wall Wart":
This wall wart is the "regular" linear type, and not the
switching type that creates electrical noise. It is rated
at 15 V DC at 800 ma, and is used on a variety of TenTec
items.
It works fine and looks like new. $15
25 Amp Power Supplies, ideal for most any HF rig:
All are rated at 25 amps, work fine and look great, and
include paper work.
Pyramid Phase III, PS-25
This power supply will furnish up to 25 amps. The voltage
is adjustable from the front panel from 4.5 to 15 V DC.
It includes both an ammeter and a voltmeter on the front panel.
It would be ideal for the bench as well as for powering a rig.
This unit may be new. It is still in its original box, with the
packing material and paper work. $100
Radio Shack 22-510 is a 13.8 V DC switching power supply
rated at 25 amps continuous duty. Note the 100% duty cycle
rating! It should easily power most any modern HF transceiver.
It is small and relatively light weight.
This unit works 100%, and looks extremely nice -- close to new.
It includes paper work -- operating manual, parts list, schematic,
and circuit board layout. $65
MFJ 4225 MV, 22 amp Continuous Power Supply:
This is a rugged, but light weight power supply that will power
most anything in your shack, whether an HF rig, or VHF and
UHF rigs. Electrically, it is extremely quiet. I could find no
noise.
Specifications:
25 Amps Surge, 22 Amps Continuous at 13.8 Vdc
Front Panel Adjustable Voltage (9-15 Vdc)
Lightweight, only 4.2 lbs.
Compact, only 5 ¾" W x 4 ½" H x 6" D
Two output connections:
Five-Way binding post for HF/VHF radio
Cigarette Lighter Socket for mobile accessories
Over Voltage Protection
Over Current Protection
Automatic Reset after shutdown
LIGHTED Dual Meters:
Volt-meter and Amp-meter monitor load continuously
Quiet internal Cooling Fan with "Fan On" LED
This one works fine and looks like new.
Complete with paper work for $70.
Cable for Hercules 444 Amplifier
This cable is used to connect the Hercules (Original 444) to
its power supply. Heavy duty cable, with heavy Molex type
connectors on each end. Nice condition. $25
VOX board for TenTec 262 Power supply
Ready to plug in to replace your defective board.
$10
TenTec 715-I cable
This cable is made to plug into the TenTec 715 RF Speech Processor
on one end, and an Icom transceiver at the other end. This is
the round 8 pin mic connector used on Icom rigs such as the IC-735,
756 series, and many others. It is NOT for the type that takes the
modular plug.
This one works fine and looks like new. $18
TenTec 720 adapter
Adapts an Icom microphone with the round 8 pin connector to a rig
requiring the TenTec / Yaesu round 8 pin connector. Like new. $15
Cables for CW keyers and keys:
Cable for paddles
About 3 feet long, and with a 1/8 inch (3.5 mm) stereo
connector on the end, like used by most rigs. $8
As above, but 1/4 inch plug. $8
Cable for straight key
About 3 feet long, with a mono 1/8 inch (3.5 mm) phone
plug on it, as used with a straight key. $5
As above, but 1/4 inch plug. $5
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs,
antennas, etc. Just too many things to list here.
Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|