I had the same problem with my OMNI D the PS is bad mine blew the Bridge
Rectifer and the 3055 Voltage Regulators were leaky I also replaced the
electrolytic cap it was old Now it works like a champ Oh BTW check output
with a known good DVM and I also Scoped PS for clean power.(no 60 cy
ripple. Im an old USN Aviation Tech KD8BTQ ---Ralph
On Sun, Feb 8, 2015 at 11:41 PM, Chris Howard w0ep <w0ep@w0ep.us> wrote:
>
> I was tuning up the antenna with my Omni-D yesterday
> afternoon and everything went completely dead.
> I was not high on SWR and not turned up to maximum power.
>
> Turning things off and on I was able to get the power
> supply meter light to come on, but nothing on the rig.
>
> I have the light in my SWR meter hooked up to the supply
> also, and that is not working. I think the supply has
> problems.
>
> -- later --
>
> I jumper the "SW" ports of the connector, plugged in
> in the supply and fired it up. Sure enough, the supply
> lights up but no output.
>
> Any advice before I dive in?
>
> Chris
> w0ep
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|