Reading what had been posted on the topic of locating a 9 MHz tap on an
older EAGLE I opened up my EAGLE to investigate. What I found on the left side
of the rig was a small pc board mounted by one screw on a vertically positioned
shield. There are two mini-coax cables running to it.
As you look at the board (mounted) I soldered a mini coax cable to the
“top” coax connector. Then I was able to run that coax along that shield for
the length of that pcbd and towards the rear panel. A small hole was drilled in
the rear panel to feed that coax out the rear. I took a few pictures if you’re
interested- email me.
In a related issue, my problem now is to get software to work with it.
After loading the Ensemble II software it keys me to use the easier fast load
of the required files. I haven’t been able to bring up the DAQ file for the
Ensemble II once the loading program has been loaded, it keeps reverting to an
earlier file that was used a few years ago with the Raocmite40 receiver.
What software is proven to work with the Ensemble II?
73 de Dave, K1OPQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|