TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Questions

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II Questions
From: Carl Moreschi <n4py3@earthlink.net>
Reply-to: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 18 Dec 2014 19:48:30 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I completely disagree with setting the audio gain high. This almost completely defeats the beautiful AGC system in the Orion.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/18/2014 7:10 PM, Barry N1EU wrote:
Dave, you'll probably get a bunch of comments.  I find the AGC settings
very non-critical and just leave them at default.  What IS important, is to
use relatively high AF Gain and low RF Gain.  First, find your AF Gain
setting: turn preamp on, ATT off, and set RF Gain to 100 and tune in a
strong s9++ signal.  Set the AF Gain to the maximum listening level that is
comfortably tolerable.  Now, leave your AF Gain setting there.  Back off
the RF Gain so that you just hear the band noise.  You're good to go.  If
you want, read http://www.tentecwiki.org/doku.php?id=565_566_588_rf_af_gain

I think #2 is normal and don't worry about it.  Enjoy the radio.

73, Barry N1EU

On Thu, Dec 18, 2014 at 6:08 PM, David and Dianne on Comcast<
dhhdeh@comcast.net>  wrote:

Hi All,

I recently acquired an Orion II and am getting used to it more each day. I
have two questions for any Orion users in the group.

#1- I am using the factory default settings for the AGC fast, medium and
slow values. Can anyone suggest any values that they use which may seem
better? Is there a tutorial on-line or a repository of AGC values
maintained anywhere for reference? I have not ventured into the
programmable AGC world yet with the Orion II

#2- In adjusting some… but not all menu values with the multi-knob
encoder, I find that it sometimes generates a bit of “flutter” in between
some value settings and seems a bit imprecise. Is this normal or should I
investigate replacing the multi-knob encoder at some point? This Orion II
is quite new dating to spring 2013 manufacture and was back to TT in
November of this year for a check out by them with nothing noted by them in
this regard. It’s not a biggie but I am curious if others have noticed this
phenomenon.

I came to the Orion II from the K3, which I still own and which I have
held as the benchmark for HF RX performance since 2008. But this receiver
is quite spectacular, very special and far more pleasing to my ears. Who
knew!?! Just a joy to use. Digital RX that sounds like old-time analog RX.
Well done TT!

Thanks for any input that can be given on my two questions above.

73 de N1LQ-Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>