The Jupiter was developed as the "Pegasus FP" -- FP for Front Panel.
A Jupiter IS a Pegasus, but a Pegasus is NOT a Jupiter -- the Jupiter has an
additional command set when not emulating the Pegasus.
The Pegasus/Jupiter has an interesting history, you can find out a lot with
a little bit of searching the Internet. Especially when you compare it to
the Kachina 505 DSP rig, which sold new (at the time) for circa $2000 -- the
Pegasus outperformed it (a point I know some will argue) for about half the
cost, IIRC.
73, ron w3wn
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Richards
Sent: Tuesday, November 25, 2014 4:16 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Relationship between the Pegasus and Jupiter -
TT Equipment Question:
What is the technical relationship between the Pegasus and Jupiter - do
they use different command sets? Are they the same rig, but one has a
set of front panel controls? Is there a previously written explanation
of this I can read?
Thanks.
----------------------K8JHR -------------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|