Which TT radio are you hanging the SDR from?
73 & DX,
Gary - AB9M
-----Original Message-----
From: Don Rasmussen via TenTec
Sent: Friday, November 07, 2014 4:43 PM
To: tentec@contesting.com
Subject: [TenTec] (no subject)
That sounds great Carl, the transceiver and SDR can both be tuned by the
main tuning knob of the transceiver.
Anyone have suggestions on sharing the antenna?
The second receiver needs to have it's input grounded before the transceiver
puts RF on the line.
=======================================================
That will work well for you. My N4PY software can provide everything you
need to keep the softrock and your transceiver on the same frequency.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com On 11/5/2014 11:34 AM, Don Rasmussen via TenTec wrote:
After all this talk about the new Flex Series and peripherals it seems all
of
my objections have melted away except for the oldest one - cost! Flex 6300
with
FX-PAD and TMate2 are outside of my ham radio budget but only because I have
that amount of money tied up in existing gear that I enjoy. I did decide to
take a look at what Tony Parks has been up to and found a very
inexpensive SDR project for the holidays. I can enjoy the build and then
mess
with the software. The 1.8-30Mhz receiver is $68 and the option cabinet is
$20. http://tinyurl.com/qx4ha8p
_______________________________________________
TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|