Yes, RTTY is a carrier mode much like CW. PSK is an analog mode as most use
it. Therefore linearity is very important to transmit a good quality signal.
Bob, K4TAX
Sent from my iPhone
> On Sep 22, 2014, at 9:23 AM, Mike Bryce <prosolar@sssnet.com> wrote:
>
> back in the day,
>
> I ran RTTY on HF with a Triton 4.
>
> You ran it at full bore, keeping the ALC LED just from lighting.
>
> The limits were how the power supply could handle the 20 amp draw for 10
> minutes or more (running those rtty pictures!)
> The triton was one of a very small group that could handle full power key
> down for hours at at time.
>
>
> Mike Bryce, WB8VGE
> the heathkit shop
> SunLight energy systems
> J e e p
> o|||||||o
>
>
>
>
>
>
>> On Sep 22, 2014, at 8:15 AM, Bob McGraw - K4TAX <RMcGraw@Blomand.net> wrote:
>>
>> What ever level it takes to keep below the ALC threshold would be the
>> correct power level. Same for the 100 watt rigs too.
>>
>> However, with the Argonaut VI the ALC circuit is of different design and one
>> can run a full 10 watts.
>>
>> In all cases, do not have any Speech Processing engaged.
>>
>> 73
>> Bob, K4TAX
>>
>>
>>
>>
>> ----- Original Message ----- From: <kd2e@comcast.net>
>> To: <tentec@contesting.com>
>> Sent: Sunday, September 21, 2014 9:43 PM
>> Subject: [TenTec] Argo V and digital modes
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|