I apologize. I must really not be smart. I still can't get it to do this. Even
with DSP and trying
ESP.
What eexactly am I DOING when the "filter automatically switches with the BW
selection"
I can switch between BW and PBT and vary these. Nothing happens to the I.F.
selection. The
book says they are DSP controls and have nothing to do with selecting the 500
Hz filter... Is
there some other BW control I have not spotted yet?
What am I doing wrong? Please spell out how to do it exactly.
On 10 Jul 2014 at 19:17, Bob McGraw - K4TAX wrote:
> The filter automatically switches with the BW selection. Observe the display
> at the left where you see "IF" The selected filter is then shown to the
> right of this label. For this to happen, the MENU selection for I-F FILTER
> must be set to AUTO.
>
> Otherwise one can select the filter of their choice with the selection of
> values at this line.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: <bcarling@cfl.rr.com>
> To: <tentec@contesting.com>
> Sent: Thursday, July 10, 2014 6:42 PM
> Subject: [TenTec] Invoking OM7 500 Hz filter ?
>
>
> > Hello,
> >
> > I now have a clean sounding OMNI VII after doing a master reset. Thanks
> > guys.
> >
> > Does anyone know how to invoke the 500 Hz Collins filter once it is
> > installed and enabled?
> >
> > I have read the manual through twice and still can't figure out how to
> > switch from 2.5 kHz
> > filter to 500 Hz !! Maybe I am not too smart. The book seems to dance all
> > around the topic
> > but never tell you how!
> >
> > 73 - Brian, AF4K
> >
> > Brian Carling, Radio AF4K
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|