TenTec
[Top] [All Lists]

Re: [TenTec] Eagle problem?

To: tentec@contesting.com
Subject: Re: [TenTec] Eagle problem?
From: Carter <k8vt@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 31 May 2014 19:54:09 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Sorry for the delayed response -- been out of the loop for awhile...

On 5/18/2014 12:41 AM, Rick - DJ0IP / NJ0IP wrote:
Carter,

> Your two feedlines are WAY off from being balanced. Feedlines don't
> have to be perfectly balanced. 10% is good enough.  Even 20% probably
> isn't too bad. Yours is 44% out of balance.  That needs to be
> addressed.

No doubt true -- but if I shorten one leg to balance it on one band, will it still be unbalanced on other bands? Possibly a moot point in any event, as my climbing days are pretty much over.

> You asked us to suggest things to try. Yet you reject some of the
> stuff because you can't see why it would make any difference. Man, I
> wish I had a dollar for every time in my life where something that
> shouldn't make any difference turned out to be the culprit.

Sorry -- not arbitrarily rejected. Usually other reasons -- like being too cheap <grin> to purchase two 4:1 baluns, not practical to move the rig outside, climbing days are over, etc. Believe me, even though I am not able to implement all of the suggestions, the comments of you and others ARE appreciated!

> You have to try stuff.  All kinds of stuff.  Eventually something
> will cause the problem to dramatically change.  When that happens,
> that gives us the next clue as to what the ultimate source of the
> problem is. It's a tough problem.  Finding it obviously is not easy.

According to a recent conversation with TT tech support, early vintage Omni VI's like mine were shipped without ferrite beads on the mic jack leads, and even though TT graciously sent me the beads, they seemed to think that it still would not cure the problem. Short of moving the antenna (not possible), I may be fighting an un-winnable battle. Thus my hinting around to the group to see if anyone else here had experienced the same problem with their Omni VI (and had a fix) -- or knew of a relatively bullet-proof Yaecomwood or newer model TT.

> Yaesu hasn't had white panels for 30+ years, have they? Must be an
> FT-107 out of the late 70's, or early 80's. It would be nice to try
> as new of a radio as you can find - at least out of the mid 90's.

You are correct, it is an FT-107, probably near the vintage of the TR-7 (which worked). A newer radio does not appear to be available; had a local friend with an Icom 745 -- but when I called him, it turns out he traded it off and is currently without an HF rig.

As the antenna is not moveable, maybe the non-elegant solution is to see if anyone knows of a Yaecomwood or newer TT that is NOT susceptible to RFI. Unfortunately, this does not appear to be a parameter that is covered in the QST reviews.

73,
Carter   K8VT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>