I stopped by the Ten Tec booth today, and looked at both an Eagle and an
Omni VII that were on display. I did not open them up, but it certainly
appeared that most of the connectors appear to be mounted to the
circuit board and in their enclosure such that the connector shells to
not contact the chassis.
I then had a brief conversation with John Henry, pointing to him what
looked very much like multiple Pin One Problems in these two radios, and
that they were a likely cause of the RFI complaints currently being
discussed on this reflector. He seemed to be paying attention. Because
he was quite busy in the booth, I purposely kept our discussion brief.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|