There are so many possible causes for this problem. In avionics installations,
we try to keep all transmission lines from various radios away from each other
as much as possible. Maybe a coax line inside your rig is has a broken shield
connection, or is coupling rf to another circuit ?
Doug Reid
WD4LNW
-----Original Message-----
From: Scott Shepard <scottsheppard@videotron.ca>
To: tentec <tentec@contesting.com>
Sent: Mon, Feb 24, 2014 5:30 pm
Subject: [TenTec] Does this happen to you on transmit...OMNI V ??
I am going thru a variety of projects presently and am now at the omni V ...it
eems on most bands above 80 m if I increase power to past 3/4 point the display
lanks out and it gets stuck in tx mode...as though swamped with RF...I have the
ew chip 9.v2 ...I have to turn the rig off in order to reset the controls...any
deas or similar experience?
Kind regards
Scott VA3IED
Sent from my iPad
______________________________________________
enTec mailing list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|