Initially seems like a RFI issue to me.
1. Try it on a known good dummy load with a known good jumper between the
radio and the load.
2. Make sure the DC power connections and connectors, both on the cable and
at the radio are solid, clean and tight.
3. Make sure the power supply voltage is correct at the radio and thus the
PS regulator is not falling out of regulation.
If it works on #1 then it is likely the antenna or the associated jumpers
connecting various pieces of equipment.
73
Bob, K4TAX
----- Original Message -----
From: "Scott Shepard" <scottsheppard@videotron.ca>
To: <tentec@contesting.com>
Sent: Monday, February 24, 2014 4:29 PM
Subject: [TenTec] Does this happen to you on transmit...OMNI V ??
I am going thru a variety of projects presently and am now at the omni V
...it seems on most bands above 80 m if I increase power to past 3/4 point
the display blanks out and it gets stuck in tx mode...as though swamped
with RF...I have the new chip 9.v2 ...I have to turn the rig off in order
to reset the controls...any ideas or similar experience?
Kind regards
Scott VA3IED
Sent from my iPad
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|