Re: [TenTec] TenTec Digest, Vol 129, Issue 1

[Mike Chatfield <mikechat@embarqmail.com>]

 Hank,

 It took me a while to trace this one down too. I have done a RAM Clear 
and Master Reset but it still does it. I have learned to SHUT OFF the 
SAF before powering down. That is the only problem I have found so far. 
But I will check the Line Out also.
 Tnx for the Reply.

 73
 Mike
 W0BBC
On 9/1/2013 1:31 PM, Pfizenmayer wrote:
> I had virtually the same problem but mine was that it shut off the 
> line out audio
> so my RTTY/PSK did not work. Drove me nuts chasing that one down .
>
> Also once in a while - it would put put a nice clean  1 v pp
> sine wave in audio range out of line out.
>
> Hank K7HP
>
>
> > Message: 1
> > Date: Sat, 31 Aug 2013 13:18:37 -0500
> > From: Mike Chatfield <mikechat@embarqmail.com>
> > To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> > Subject: [TenTec] Orion II SAF issue when left on and power down then
> > power up
> > Message-ID: <5222337D.8080804@embarqmail.com>
> > Content-Type: text/plain; charset=ISO-8859-1; format=flowed
> >
> > I am running version 3.033xa just installed a couple of days ago. I
> > noticed an interested problem with the SAF.
> > If I leave SAF (Main Receiver) on and power down, then bring the Orion
> > II back on I get NO receive audio (mostly just popping noise) on the
> > Main receiver. In order to get the audio to work I must shut off SAF
> > then do a power cycle, it works fine then.
> > As long as I remember to shut off the SAF BEFORE powering off everything
> > works fine.
> > As anyone seen this issue?
> > Not a big deal but it looks like a firmware issue...
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec