I had virtually the same problem but mine was that it shut off the line out
audio
so my RTTY/PSK did not work. Drove me nuts chasing that one down .
Also once in a while - it would put put a nice clean 1 v pp
sine wave in audio range out of line out.
Hank K7HP
Message: 1
Date: Sat, 31 Aug 2013 13:18:37 -0500
From: Mike Chatfield <mikechat@embarqmail.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] Orion II SAF issue when left on and power down then
power up
Message-ID: <5222337D.8080804@embarqmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
I am running version 3.033xa just installed a couple of days ago. I
noticed an interested problem with the SAF.
If I leave SAF (Main Receiver) on and power down, then bring the Orion
II back on I get NO receive audio (mostly just popping noise) on the
Main receiver. In order to get the audio to work I must shut off SAF
then do a power cycle, it works fine then.
As long as I remember to shut off the SAF BEFORE powering off everything
works fine.
As anyone seen this issue?
Not a big deal but it looks like a firmware issue...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|