Of course it does.
It has a "T" line inside which goes positive whenever the ARG.V goes into
transmit.
This enables all the other stages needed to transmit.
It can also be used as a signal to key the external linear.
All you need do is tap into that signal, buffer it with a transistor and
drive a small reed relay. The reed relay's NO contacts can be used to key
the external amplifier.
Of course you will probably need to drill a hole in the back panel for
mounting an RCA phono jack, and you'll need to solder a few connections, but
it's quite easy.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mark N8COO
Sent: Tuesday, August 06, 2013 3:52 AM
To: tentec@contesting.com
Subject: Re: [TenTec] Argo V amp keying
The Argonaut V does not have any provision for keying an external amp.
73, Mark N8COO
Date: Sun, 04 Aug 2013 14:41:33 -0400
> From: Dave Edwards <kd2e@comcast.net>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: [TenTec] Argo V amp keying
> Message-ID: <51FEA05D.7000901@comcast.net>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
>
> I would like to try keying an amp with my Argo V.
>
> The ACC din plug has a connector labelled "PTT"
> The manual indicates this is for remote keying the radio with a TU or
> whatever.
>
> Does anyone know if it also provides a closure upon transmit?
>
> ....Dave
>
>
>
>
> --
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|