If, you use a bulb other than Ten Tec Original or an exact replacement.
Beware!!! Look carefully at the current rating of the bulb/s. Looking at
the Omni D Schematic you will see that the voltage to run the pilot bulbs
is taken from the Regulated Supply Voltage. This is the Regulated Supply
for the LMO and other Voltage Sensitive Circuits. It is very easy to
overload this Supply Line with TOO MUCH CURRENT. I was given one of my Omni
D radio's because the guy could not make it stop Dropping about 200 HZ in
Frequency when he keyed the Microphone. It seems that the extra current
drawn when switched to transmit was too much for the little regulator
circuit. After noticing that the Meter Bulb was burning very dark and Dull.
I removed the Meter Lamp and the radio became Rock Solid where Transmit and
Receiver Tracking are concerned. I then got some LED's and Resistors from
the Phone Shack ( Once known as Radio Shack ) ..... With a little bit of
Ham Engineering the radio works Great now and the Meter looks Great also.
On air reports confirmed this problem by talking on the radio with the
Meter Bulb installed and then with it out of the radio. LED's are the way
to go if, you want my advise. No special formula for me Just placed 3 LED
lamps in series and decreased the resistance of a 1k Pot until the
brightness I wanted was achieved. Also, checked to see that the LED's were
not producing any heat. A Cool LED is a Happy LED.....
73 to all de Wade/KJ4WS
On Fri, Jun 7, 2013 at 5:49 AM, Vic Klein <vhklein@ptd.net> wrote:
> When I needed to replace the 6v, 50ma dial lamps in my Triton I a while
> back, I found they were made from unobtanium or very expensive, even
> through
> Ten Tec. However, as memory serves, they are wired in series across the 12v
> bus and small 12v lamps with leads could be easily wired in parallel to fit
> the same slots in the bezel, so that is what I did. I looked at using 12v
> LEDs, but these bulbs are positioned to light the dial positioned
> vertically, and an LED puts all it light out toward the top, so they just
> wouldn't work. 2-packs of 12v lamps are around $2 at Radio Shack.
>
> =Vic=
> WA4THR
>
>
>
> ----------------------------------------------------------------------------
> ---------------------------------
> To: "tentec@contesting.com" <tentec@contesting.com>
> Subject: [TenTec] dial lights for OMNI D and Model 544 Triton
> From: John King <k5pgw@yahoo.com>
> Reply-to: John King <k5pgw@yahoo.com>, Discussion of Ten-Tec Equipment
> <tentec@contesting.com>
> Date: Thu, 6 Jun 2013 11:11:15 -0700 (PDT)
> List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
>
> Can someone please supply me with the correct dial light numbers fir the
> Ten
>
> Tec OMNI D and the Ten Tec Triton 544 transceivers. I will great;t
> appreciate
> the information. 73, John, K5PGW
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|