TenTec
[Top] [All Lists]

Re: [TenTec] dial lights for OMNI D and Model 544 Triton

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] dial lights for OMNI D and Model 544 Triton
From: davkozy@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 7 Jun 2013 16:24:26 +0000 (UTC)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

How do you determine the proper resistance? 



Is it try different values until you find the intensity you desire? 



Does anyone have suggestions for combinations that match the exixiting lamps? 


Dave K. 

----- Original Message -----
From: "Richard Detweiler" <rdetweil@hotmail.com> 
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> 
Sent: Friday, June 7, 2013 9:21:55 AM 
Subject: Re: [TenTec] dial lights for OMNI D and Model 544 Triton 

Most people these days get the LED lamps in soft yellow glow, maybe a nickle at 
the local store, add a resistor to match the lumens desired and you are back in 
bussiness, 

  

This was especially usefull for the dial lamp just above the tuning knob as it 
needed a very small lamp. 

Best Wishes 
Richard 


  

> From: vhklein@ptd.net 
> To: tentec@contesting.com 
> Date: Fri, 7 Jun 2013 06:49:11 -0400 
> Subject: Re: [TenTec] dial lights for OMNI D and Model 544 Triton 
> 
> When I needed to replace the 6v, 50ma dial lamps in my Triton I a while 
> back, I found they were made from unobtanium or very expensive, even through 
> Ten Tec. However, as memory serves, they are wired in series across the 12v 
> bus and small 12v lamps with leads could be easily wired in parallel to fit 
> the same slots in the bezel, so that is what I did. I looked at using 12v 
> LEDs, but these bulbs are positioned to light the dial positioned 
> vertically, and an LED puts all it light out toward the top, so they just 
> wouldn't work. 2-packs of 12v lamps are around $2 at Radio Shack. 
> 
> =Vic= 
> WA4THR 
> 
> 
> ---------------------------------------------------------------------------- 
> --------------------------------- 
> To: "tentec@contesting.com" <tentec@contesting.com> 
> Subject: [TenTec] dial lights for OMNI D and Model 544 Triton 
> From: John King <k5pgw@yahoo.com> 
> Reply-to: John King <k5pgw@yahoo.com>, Discussion of Ten-Tec Equipment 
> <tentec@contesting.com> 
> Date: Thu, 6 Jun 2013 11:11:15 -0700 (PDT) 
> List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
> 
> Can someone please supply me with the correct dial light numbers fir the Ten 
> 
> Tec OMNI D and the Ten Tec Triton 544 transceivers. I will great;t 
> appreciate 
> the information. 73, John, K5PGW 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec@contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 
                                                
_______________________________________________ 
TenTec mailing list 
TenTec@contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>