Hello All,
I am curious, did the PLL Lock problem from the original Paragon persist into
the Paragon II, or had it been corrected by then?
Thanks,
73 Frank W3UHF
On Jun 1, 2013, at 3:32 PM, Carl Moreschi wrote:
I wrote the Paragon II firmware for Tentec. I don't know how many were sold
but I am guessing only a few hundred. It's a great general coverage radio and
works quite well on the ham bands for DX.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 6/1/2013 3:24 PM, Peter Bertini wrote:
After owning an Omni VI for a few months I had a hankering to try the
Paragon II transceiver. I was lucky enough to find one in working condition
a few months later. I've been able to add a full filter compliment since
obtaining the radio. Why? I was interested in the ability to open up the
TX range to cover between 160 and 10 meters with no gaps.
I'm kind of curious to know how rare the Paragon II transceivers might
be... I haven't seen a lot of information about them, and I assume that
very few were manufactured before the Paragon line was discontinued.
Pete
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
73, Frank A. Ellis, W3UHF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec