Hello All,
I am curious, did the PLL Lock problem from the original Paragon persist into
the Paragon II, or had it been corrected by then?
Thanks,
73 Frank W3UHF
On Jun 1, 2013, at 3:32 PM, Carl Moreschi wrote:
> I wrote the Paragon II firmware for Tentec. I don't know how many were sold
> but I am guessing only a few hundred. It's a great general coverage radio
> and works quite well on the ham bands for DX.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 6/1/2013 3:24 PM, Peter Bertini wrote:
>> After owning an Omni VI for a few months I had a hankering to try the
>> Paragon II transceiver. I was lucky enough to find one in working condition
>> a few months later. I've been able to add a full filter compliment since
>> obtaining the radio. Why? I was interested in the ability to open up the
>> TX range to cover between 160 and 10 meters with no gaps.
>>
>> I'm kind of curious to know how rare the Paragon II transceivers might
>> be... I haven't seen a lot of information about them, and I assume that
>> very few were manufactured before the Paragon line was discontinued.
>>
>> Pete
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
73, Frank A. Ellis, W3UHF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|