If you can't track it down from the other suggestions, try keying the TX
with a straight key connected to the key jack. I found a keying problem on
another Ten-Tec rig than needed a really solid ground to get a good
sounding CW signal. A keyer wasn't good enough.
Hope this helps.
73,
ed - k9ew
On Sun, May 12, 2013 at 10:57 PM, Haney Howell <haney.howell@gmail.com>wrote:
> Delighted with my newly found 509. Only gig is a bit of a chirp (although
> I suspect it helps to stand out in the clutter)!
>
> Any hints on troubleshooting this gem?
>
> Haney Howell
> K2XN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|